Contact Us

Command Electronics, Inc
15670 Morris Industrial Dr.
Schoolcraft, Michigan 49087

PHONE: (269) 679-4011 Fax: (269) 679-5410
Email: info@commandelectronics.com

15670 Morris Industrial Dr
Schoolcraft, MI, 49087
United States

(269) 679-4011

Misc Products

K-43UPG: LED UPGRADE FOR REVOLUTIONARY STYLE EXTERIOR LIGHTS

K-43UpgThumb-214x192.jpg
K-43UpgThumb-214x192.jpg

K-43UPG: LED UPGRADE FOR REVOLUTIONARY STYLE EXTERIOR LIGHTS

22.95

An easy upgrade to convert your 007-43 or 007-44 lights to LED.

Product Data Sheet

Quantity:
Add To Cart

An easy upgrade to convert your 007-43 or 007-44 lights to LED. We supply an LED panel with 30 cool white LEDs for maximum light output and a new lens mounting gasket. This LED panel develops 600 lumens .

Electrical draw is reduced from 2.1 amps per bulb to 0.47 amps.

Change your Command Electronics Revolutionary Design security or security porch light to LED with this easy kit. Installation is as easy as removing 4 screws, pulling out the incandescent 1156 bulb and plugging in the 30 LED replacement panel. Up to 600 lumens (cool white) of lighting are available at a fraction of the electrical amp draw of the standard 1156 incandescent bulb.

Our popular Revolutionary Design security light is found on many popular trailers including Keystone, Dutchmen, Crossroads, Jag, KZ, Redwood, Evergreen, Lakota, Open Range Gulstream, Roadmaster and R-Vision brands. This LED upgrade kit will work with either our 007-43 or 007-44 lights. The kit includes a replacement LED board, instructions, and a replacement inner gasket for proper sealing.

EASY INSTALLATION STEPS:

Remove the lens. Note the placement of the inner gasket. A new replacement gasket is included in your kit.

Remove the light bulb and clean the stainless steel base with a bit of glass cleaner to remove any dirt or oil.

The LED board plugs right into the socket that held the bulb. You may wish to bend the socket up a bit to give some additional clearance for the LED board. This will allow you to slide the LED board a bit further to the center.

Peel off the double faced tape on the back of the LED board and press down onto the steel plate.

Replace the inner gasket as shown.

When re-attaching the lens, take note that there is a Top and a Bottom to the lens. Mount the lens with the drain slot at the bottom.